4 min read
ADAM T5V and T7V settings and placement
Leave LF and HF at 0 if the speakers sit 16 inches or more from walls. Closer than that, set LF to -2 dB. Use HF only for a dull or bright room, and keep the level knob at 0 dB.
4 min read
JBL 305P MkII boundary EQ, HF trim and placement
Use 0 dB on stands away from walls, -1.5 dB on a desk near a wall, and -3 dB right against a wall or in a corner. Leave HF Trim at 0 unless your room is bright or dull.
4 min read
Kali LP-6 DIP switch settings for every placement
Switches 1 to 3 tell the speaker where it sits, from all down on stands away from walls to all up on a desk against a wall. 4 and 5 trim the bass, 6 and 7 the treble, 8 turns on RCA.
5 min read
KRK Rokit G4 and G5 EQ settings for your room
Start with LOW EQ and HIGH EQ at 3 (flat). On a desk near a wall, try LOW EQ 2. Use 1 for a wall or corner and 4 for a muddy desk. Skip 5 if your room already booms.
4 min read
Yamaha HS8, HS7 and HS5 room control settings
Start both switches at 0. Use ROOM CONTROL -2 on a desk near a wall and -4 in a corner, then check by ear. HIGH TRIM is for a bright or dull room, not for boom.
2 min read
Rear-ported monitors near a wall
Monitors with a hole in the back get extra bass when they sit close to a wall. Give them space, use the back-panel switch, and plug the port if you must.
2 min read
Why do my studio monitors sound boomy?
Boomy monitors are almost always a boomy room. A few bass notes pile up where you sit. Check placement first, then find and turn down the note that's left.
4 min read
How far should studio monitors be from the wall?
Close to it, with a small gap and the back-panel switch set, or far from it. Halfway out puts a dip right on your kick drum and bass.